![]() ![]() This level also controls the detection of OFDM Orthogonal Frequency Division Multiplexing. This level enables power-based packet detection by controlling the amount of power increase that makes a radio aware that it has received a packet. Select to increase the immunity level to improve performance in high-interference environments. You can specify a value within the range of 60-500. beacon management frames are transmitted by the access point. 802.11 standards use the Ethernet protocol and Carrier Sense Multiple Access with collision avoidance (CSMA/CA) for path sharing. This indicates how often the 802.11 802.11 is an evolving family of specifications for wireless LANs developed by a working group of the Institute of Electrical and Electronics Engineers (IEEE). This option is set to Disabled by default.Įnter the Beacon period for the Instant AP in milliseconds. It is used to regulate the power levels used by 802.11a radio cards. Transmit Power Control (TPC) reduces the radio frequency (RF) output power of each network transmitter to a level that minimizes the risk of interference. Dynamic Frequency Selection (DFS) detects the presence of other devices on a channel and automatically switches the network to another channel if and when such signals are detected. (Country Information) and 802.11h 802.11h is intended to resolve interference issues introduced by the use of 802.11a in some locations, particularly with military Radar systems and medical devices. Rules are subject to variation and include allowed frequencies, allowed power levels, and allowed signal bandwidth. Select Enabled to allow the radio to advertise its 802.11d 802.11d is a wireless network communications specification for use in countries where systems using other standards in the 802.11 family are not allowed to operate.Ĭonfiguration can be fine-tuned at the Media Access Control (MAC) layer level to comply with the rules of the country or district in which the network is to be used. This option is set to Disabled by default. With 802.11n, there will be a significant increase in the maximum raw data rate from 54 Mbps to 600 Mbps with the use of four spatial streams at a channel width of 40 MHz. Select Enabled to run the radio in non- 802.11n 802.11n is a wireless networking standard to improve network throughput over the two previous standards, 802.11a and 802.11g. However, the same zone name cannot be configured on two different 2.4 GHz Gigahertz. The same zone name can be configured on a 2.4 GHz Gigahertz. radio profile.Įnter the zone name for configuration. ![]() Configure the parameters listed in the following table:Įnter a name for the 2.4 GHz Gigahertz. Under 2.4.GHz band or 5 GHz band, click New.ĥ. Click the RF link located directly above the Search bar of the Instant main window.Ģ. A console interface with a command line shell that allows users to execute text input as commands and convert these commands to appropriate functions. radio settings for a n Instant AP either using the WebUI or the CLI Command-Line Interface. The current Radio profile is displayed as Default. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |